STEP 1.Begin by removing trim bezel that surrounds climate control. Insert hook tool in upper right corner of bezel, hooking tool behind bezel, and pulling towards you . Use hook tool on all four
corners of bezel to release four (4) clips, two (2) on the top of bezel and two (2) on bottom of bezel. Let bezel hang. (HINT) Clips are very tight so pull firmly.
STEP 2.
Using Phillips screwdriver, remove factory screw on left side of climate control. Attach hang-up cup onto Pro.Fit mount.
STEP 3.
Position Pro.Fit mount over screw hole. Replace and tighten factory screw. With drill and 5/64” drill bit, drill starter hole using Pro.Fitmount as a guide. Insert provided screw and tighten with
Phillips screwdriver. Reassemble trim bezel.
No comments:
Post a Comment